6.2.2.2 Single Sized Headband Kit

1 Step 1 - measure you patient’s head circumference
2 Step 2 - choose the correct head band
3 Step 3 - slide the headband through the sensor latches
4 Step 4 - attach the turnbuckle to the headband

Step 1 - measure you patient’s head circumference

Using a measuring tape, measure the largest circumference of the patient’s head at the most prominent part on the back (occipital) and just above the eyebrows (supraorbital ridges). The available headband options range from five to seven, depending on the headband set provided.

back to top

Step 2 - choose the correct head band

Based on the measured head circumference, select the appropriate band size as specified in the table below.

Individually sized headband stripes

Code	Size	Head circumference

Code	Size	Head circumference
531020017	PP (XS)	50 – 55 cm (19 5/8 – 21 5/8 in)
531020018	P (S)	52,5 – 57,5 cm (20 5/8 – 22 5/8 in)
531020019	M (M)	55 – 60 cm (21 5/8 – 23 5/8 in)
531020020	G (L)	57,5 – 62,5 cm (22 5/8 – 24 5/8 in)
531020021	GG (XL)	60 – 65 cm (23 5/8 – 25 5/8 in)
Special sizes (supplied separately)
531020016	PPP (2XS)	47,5 – 52,5 cm (18 3/4 - 20 5/8 in)
531020022	GGG (2XL)	62,5 – 67,5 cm (24 5/8 – 26 5/8 in)

TIP - Most adults will need an M and L size while children typically use S or XS size headband.

back to top

Step 3 - slide the headband through the sensor latches

1	If the external battery is installed, remove it by pressing the side buttons and pulling it upwards, as shown in the figure.	external battery removal
2	Slide the selected headband strap through the sensor notches as depicted in the figure.

back to top

Step 4 - attach the turnbuckle to the headband

Complete the headband assembly by attaching the turnbuckle to both ends of the headband strap.

back to top | go to logging into app