6.2.2.2 Individually-Sized Headband Kit

1 Step 1 - measure you patient’s head circumference
2 Step 2 - choose the correct head band
3 Step 3 - slide the headband through the sensor latches
4 Step 4 - attach the turnbuckle to the headband

Individually sized headband stripes

Step 1 - measure you patient’s head circumference

With a measuring tape, measure the largest circumference of your patient’s head, i.e., the most prominent part on the back of the head (occipital) and just above the eyebrows (supraorbital ridges). There are five to seven headband options available (depends on which headband set was sent).

Step 2 - choose the correct head band

According to the measured head circumference, choose the band size defined in the table bellow.

Code	Size	Head circumference

Code	Size	Head circumference
531020017	PP (XS)	50 – 55 cm (19 5/8 – 21 5/8 in)
531020018	P (S)	52,5 – 57,5 cm (20 5/8 – 22 5/8 in)
531020019	M (M)	55 – 60 cm (21 5/8 – 23 5/8 in)
531020020	G (L)	57,5 – 62,5 cm (22 5/8 – 24 5/8 in)
531020021	GG (XL)	60 – 65 cm (23 5/8 – 25 5/8 in)
Special sizes (supplied separately)
531020016	PPP (2XS)	47,5 – 52,5 cm (18 3/4 - 20 5/8 in)
531020022	GGG (2XL)	62,5 – 67,5 cm (24 5/8 – 26 5/8 in)

TIP - Most adults will need an M and L size while children typically use S or XS size headband.

Step 3 - slide the headband through the sensor latches

If the external battery is installed, remove it by pressing the side buttons pulling upwards as shown in the figure bellow.

external battery removal

Slide the selected headband stripe through the sensor notches as shown in the figure bellow. Replace the external battery in the sensor by pressing the side latches and releasing them when the battery is positioned correctly.

Step 4 - attach the turnbuckle to the headband

The final assembly of the headband is done by attaching the turnbuckle to both ends of the headband stripe.