Each external battery charger is capable of connecting with two additional chargers through its side magnetic connectors on either side, allowing up to three simultaneous charges from a single source. To charge the external battery, do the following:
ATTENTION
Do not use more than one power source with the chargers connected.
Use only the font provided by brain4care.
Do not connect more than three chargers to a single power source.
WARNING - Only original power supply and cables should be used with the charger. If not there is a risk of charger malfunction.
Do not insert conductive objects in the magnetic connector. Metallic materials can be attracted by the magnetic connector and cause short-circuit
Figure 6.9-1 External Battery Chargers.
Step 1. Plug one end of the USB-C cable that came with the product into the power source and plug it into a power outlet.
Step 2. Connect the other end of the USB-C cable to the charger. When plugging in, make sure all LEDs light up (one red and five green). Only the red LED will remain lit.
Step 3. With the charger attached, attach the external battery to the top of the charger by pressing the side latches and attaching it to the charger.
Step 4. Charging verification occurs by watching the green LEDs fl ash. If this does not occur and the LEDs remain lit, it is possible that the battery is overheated or improperly attached. Each lit LED represents a percentage range of battery charge.
Table 6.9-1 Charging ranges
1 flashing LED | 0 ~ 19% charged |
1 LED on and 1 flashing LED | 20 ~ 39% charged |
2 LEDs on and 1 flashing LED | 40 ~ 59% charged |
3 LEDs on and 1 flashing LED | 60 ~ 79% charged |
4 LEDs on and 1 flashing LED | 80 ~ 99% charged |
5 LEDs on | 100 % charged |
Step 5. Charging completion takes around three hours and is indicated when all green LEDs stop flashing and light continuously.
To uncouple the battery, press the side latches and remove it from the charger.