...
Info |
---|
ATTENTION - make sure the steps below have been completed:
|
...
Step 1 - start
...
session
From the main screen click on new session (1) button to start monitoring session.
...
Tip |
---|
TIP - if activated for your corporate account you can tag your monitoring session reports. Please refer to 6.6.2 tag monitoring sessions (optional) |
...
Step 3 -
...
verify positioning (optional)
Once satisfied with the pulse morphology displayed on the app’s sensor positioning screen Figure 6.6-5, click the start monitoring button (1).
Info |
---|
ATTENTION - For instructions on how to position the sensor and verify the waveform technical quality please read please refer to 6.6 position sensor section of this user guide. |
...
Step 4 - monitor patient
Once monitoring has started, a screen is shown in the mobile app, as shown in the figure below, where some information is presented to aid monitoring.
...
No. | Function | Description |
---|---|---|
1 | Edit patient info | Access to patient information screen for visualization and edit |
2 | morphology tab | live waveform screen showing last 5 seconds of monitoring session |
3 | trend tab | tab that shows the full or partial monitoring session waveform stream |
4 | P2P1 tab | tab that shows minute by minute derived parameter of estimated P2P1 ratio (please refer to |
5 | TTP tab | tab that shows minute by minute derived parameter of normalized time-to-peak (please refer to |
6 | Observations | Opens the notes panel to add clinical notes to the monitoring session |
7 | Partial Report | Partial report access button where the two digits before the “m” informs how many minutes of the monitoring session will be included in the report |
8 | external | External battery charge level in % (only relevant to BcSs-PICNIW-1000 sensor model) |
9 | Bluetooth signal strength | Bluetooth signal strength status. Green (good), yellow (regular) and red (bad) |
10 | internal | Internal battery charge level in % |
11 | UDI | Sensor’s Unique ID number |
12 | Monitoring time | Time elapsed since start of monitoring session |
13 | UMI | Unique Monitoring Session ID |
14 | End monitoring | End monitoring session button |
15 | Pause monitoring | Pause monitoring session button |
Step 6 - finalize monitoring session
To end the monitoring session click on end monitoring. A popup window will appear asking you to confirm the end of the monitoring session. Click on save.
...
Once the monitoring session is complete you will be directed to a confirmation screen. Here you can fill in or edit patient data before the final report is generated. You can also access a partial report by clicking on the expand/zoom button on the right side.
...