Table of Contents |
---|
To disinfect the sensor generously apply 70% ethanol alcohol to a sterilized gauze and wipe each component according to the following instructions:
...
Info |
---|
ATTENTION - Do NOT press the pin on the green base of the sensor during sterilization to avoid damaging the sensor. |
...
Step 1 - turn off sensor
Before you begin, make sure the sensor is turned off verifying that the power switch set to “O”. Figure 6.1-1a Turning off the sensor BcSs-PICNIW-1000 | Before you begin, make sure the sensor is turned off by checking if the LED is turn-on. If yes, keep pressed util the LED is turn-off Figure 6.1-1b Turning off the sensor BcSs-PICNIW-10002000 |
Step 2 - disassemble sensor if needed
...