6.10.2 in-app pairing

back to index | back to multiparameter monitor

In this pairing method, the B4C System mobile app will make the connection between the dongle and the sensor. A major benefit of this method is the ability to view the sensor waveform both on the mobile app and patient monitor and also the ability to generate a monitoring session report (please view section 6.9.1 b4c report (original) for details on the generated report).

1 Step 1 - Connect receiver (dongle)
2 Step 2 - Log into app and pair sensor
3 Step 3 - Initiate dongle pairing in mobile device
4 Step 5 - Verify matching devices in app
5 Step 6 - Confirm dongle pairing
6 Step 7 - Verify signal on patient monitor

Step 1 - Connect receiver (dongle)

back to top

Step 2 - Log into app and pair sensor

Log into app and pair sensor as explained in section 6.3 logging into app

back to top

Step 3 - Initiate dongle pairing in mobile device

Starting pairing with the dongle.

After pairing the sensor, in the application, click “Pair Receiver.” A list of available receivers will appear.

Check the receiver’s UDI on the label opposite to the button…

Choosing dongle.

…and then select it from the list

Some receivers may not be available to be clicked, represented in gray, as they are not active, locked, do not belong to the organization (corporate account), or are awaiting activation (if your sensor is grayed out, check with your clinical engineering team).

back to top

Step 5 - Verify matching devices in app

After selecting the dongle, the pairing intelligence mode between sensor and receiver will start, with a visual LED confirmation on both devices. Visually confirm the pairing with the physical receiver, with the receiver image in the mobile app. Both should be flashing matching color and blinking patter. Click “Confirm” to continue pairing. If the pattern is not identified or you want to change the receiver, simply click on “Reselect”.

Once the connection with the dongle is confirmed, you will be directed to the screen on Figure 6.8-7, where the sensor, receiver and application are paired. The same pairing intelligence method is done with the sensor, receiver, and mobile application screen by flashing in the same randomly generated color and frequency pattern.

back to top

Step 6 - Confirm dongle pairing

Verify that all three devices have the same flashing pattern and click “Confirm”. If the pattern is not identified or you want to change any of the devices, just click “Reselect”.

The sensor and receiver status LEDs will flash green three times as soon as pairing is confirmed, and a success window will appear in the application.

back to top

Step 7 - Verify signal on patient monitor

back to top