back to index | back to instructions for use
| Anchor | ||||
|---|---|---|---|---|
|
...
To turn on the sensor to initiate the pairing procedure by using the power switch, setting it to “I” position.
...
Turning ON sensor BcSs-PICNIW-1000
Make sure you are not trying the press the MODE button. This is used to pair the sensor with a dongle (please see section https://brain4care.atlassian.net/wiki/spaces/B4CSENSORGUIDE30/pages/3220246611/6.8+multiparameter+monitor+optional#6.8.1-manual-pairing if you are using a dongle)
...
A list of sensors will appear on your the sensor pairing pop-up screen ( 1 ). The closest sensor will be selected automatically. Verify if that the sensor UDI (Unique Device ID) on the sensor, located opposite the power buttons, is the same that has been selected from the sensor list matches the sensor selected in the mobile app.
| Tip |
|---|
TIP - Some sensors may not be available for selection (dimmed) because they are blocked or not active for your organization. |
...
A visual confirmation for pairing will flash. The sensor and the sensor its image in the mobile app will blink with the same color and frequency ( 2 ). If this pattern is the same the blinking pattern matches between the mobile app screen and the sensor, the chosen sensor is the correct onecorrectly selected. Click “Confirm” "Confirm" ( 3 ). If the pattern does patterns do not match or if you want to change the sensors, click the “Cancel” button wish to select a different sensor, click "Cancel" ( 4 ). Once the chosen sensor is confirmed, the sensor’s status LED on the sensor will flash green three times.
...