back to index | back to instructions for use
Anchor | ||||
---|---|---|---|---|
|
Table of Contents | ||
---|---|---|
|
...
Step 1 - measure the cranial circumference
With a measuring tape, measure the largest circumference of the patient's head, that is, the most prominent part at the back of the head (occipital) and just above the eyebrows (supraorbital ridges).
...
Step 2 - choose the correct headband stripe
...
According to the measured head circumference, choose between headband 1 and 2 according to table bellow. If you cannot find the desired size, follow procedure 6.2.4, with the extra tape provided
...
Tip |
---|
TIP - Most adults will need Headband stripe 2 |
...
Step 3 - slide the headband through the sensor latches
If the external battery is installed, remove it by pressing the side buttons pulling upwards as shown in the figure bellow.
...
Slide the selected headband stripe through the sensor notches as shown in the figure bellow. Replace the external battery in the sensor by pressing the side latches and releasing them when the battery is positioned correctly.
...
Insert excerpt | ||||||||
---|---|---|---|---|---|---|---|---|
|
...
Step 4 - attach the turnbuckle on the headband stripe
...
The final assembly of the headband should resemble the image below
...
back to top | go to logging into app