| Table of Contents | ||
|---|---|---|
|
...
Step 1 - measure you patient’s head circumference
With a measuring tape, measure the largest circumference of your patient’s head, i.e., the most prominent part on the back of the head (occipital) and just above the eyebrows (supraorbital ridges). There are five to seven headband options available (depends on which headband set was sent).
Step 2 - choose the correct head band
According to the measured head circumference, choose the band size defined in the table bellow.
...
| Tip |
|---|
TIP - Most adults will need an M and L size while children typically use S or XS size headband. |
Step 3 - Place the headband on the sensor
If the external battery is attached, remove it by pressing the side latches and pulling it up as shown in Figure bellow.
...
Pass the selected headband through the sensor notches as shown in figure bellow. Attach the external battery back on the sensor by pressing the side latches and releasing them when the battery is correctly positioned.
...
Step 4 - attach the turnbuckle to the headband
The final assembly of the headband is done by attaching the turnbuckle to both ends of the headband stripe.
...