...
Warning |
---|
WARNING - Only the original power supply and cables should be used with the charger. If not there is a risk of charger malfunction. Do not insert conductive objects in the magnetic connector. Metallic materials can be attracted by the magnetic connector and cause a short-circuit |
6.9.1 charging sensor BcSs-PICNIW-2000
Step 1 - Connect the sensor charger to AC adapter
Plug the USB-C cable that came with the charger into the AC adapter and plug it into a power outlet.
Step 2 - Place the sensor to the charger
Gently place the sensor on the charger as shown in Figure 6.9.1. When positioned correctly, the sensor will power on, and the LED lights will start flashing.
Info |
---|
ATTENTION - The sensor only charges when it is positioned with the brain4care logo and the button facing upwards. |
...
Figure 6.9.1 Place the sensor to the charger
Step 3 - Wait for the charge to happen
Charging verification occurs by watching the green LED lights flashing. If this does not occur it is possible that the battery is overheated or improperly placed.
...
6.9.2 charging sensor BcSs-PICNIW-2000
The components used to charge an external battery are identified in Figure 6.9.2-1. They are:
the external battery
charging dock station
power supply
charging cable
...
Each external battery charger is capable of connecting with two additional chargers through its side magnetic connectors (Figure 6.9.2-2) on either side, allowing up to three simultaneous charges from a single power source.
...
To charge the external battery, do the following:
Step 1 - Connect USB to power source
Plug one end of the USB-C cable that came with the product into the power source and plug it into a power outlet
...
Connect the other end of the USB-C cable to the charger. When plugging in, make sure all LEDs light up (one red and five green). Only the red LED will remain lit. (Figure 6.9.2-3)
...
Step 3 - Attach the battery to the charger
With the charger attached, attach the external battery to the top of the charger by pressing the side latches and attaching it to the charger (Figure 6.9.2-4).
...
Step 4 - Wait for the charge to happen
...
A full charge will require roughly three hours of charging and will be indicated when all green LEDs stop flashing and are light continuously. To uncouple the battery, press the side latches and remove it from the charger . (Figure 6.9.2-6).
...